English
Spanish
French
ArabicAnchor Clamps for Fiber Optic and Copper Overhead Networks
Anchors enable cables to be secured to telecom and utility poles. We offer solutions designed specifically for fiber optic aerial networks:
- Anchoring of Fiber Optic Round Cables: Crown Wealth offers a diversifiedand complete solution for ADSS cables. Our anchor clamp are designed to permanently enhance cable roll-out jobs for different network configurations.
The product range consists of two main product lines: Anchor clamps with wedge design and helical dead ends. Anchor clamps such as our ACADSS clamps are compatible with distribution network and last mile access configurations. Designed for tool-less installation, these products perform under optimal conditions of safety and efficiency. These all-in-one devices are ready to use and reusable if needed.
On transport networks characterized by greater spans, the applied tensile strength on cables is significantly important. As a consequence, there is an increased risk of signal attenuation when shorter cable sections are tightened. Helical dead ends are technically more suitable solutions to these type of network configurations. These spirals are equipped with spiral anchors significantly longer than anchor clamps’ wedges. Certain versions of our helical dead-ends are designed with protective underlayers, to install on the cables’ outer sheath.
- Anchoring forflat optical cables: Crown Wealth has developed a range of anchoring and suspension devices especially engineered for flat cables routing on aerial lines. These devices are fully compliant with the requirements on transport and distribution networks as well as last mile access.
- Anchoring for figure-8 fibre optic cables: For cable roll-outsspanning up to 180m, Crown Wealth offers anchoring drop clamps for Figure-8 cables, steel or dielectric messengers deployed on transport or distribution networks and FTTH last mile access.
